Thermal imaging and predictive maintenance in Zambia
Infrared scans of switchgear, motors, panels and heat exchangers, with a severity-rated report inside 48 hours. First scan free for new clients.
What a scan finds
Overheating connections and terminals, unbalanced loads on switchgear, failing bearings in motors and pumps, blocked or fouled heat exchangers, insulation breakdown in cables, hot spots in control panels, steam and fluid leaks, and refractory wear in furnaces and kilns.
How it works
We visit your plant with a thermal camera and diagnostic equipment, scan all critical systems under load, and log every anomaly. Within 48 hours you receive a report with thermal images, severity ratings and specific repair recommendations. You then fix on your own schedule — before the failure stops production.
The free first scan
New clients get a complimentary initial thermal scan. No obligation: if we find nothing, you lose nothing. If we find problems — and we usually do — you decide what to fix and when.
Beyond the scan
Where the scan finds a failing drive, starter, UPS or control card, the same team repairs it, and designs a replacement board if the part is discontinued.
Questions we are asked
Is the first thermal scan really free?
Yes, for new clients: an initial scan with a written report, no obligation to proceed with any repair.
How quickly do we get the report?
Within 48 hours of the site visit, with images and severity ratings.
Does the plant need to shut down?
No — the opposite. Equipment must be running under normal load for the scan to be meaningful.
Do you offer regular inspections?
Yes, on maintenance contracts, typically quarterly, so trends are tracked rather than single snapshots.
Related
Tell us what failed.
A photo of the unit and its nameplate on WhatsApp is enough to start.